Canon VB-H651VE User Manual - Page 48

(9) [Control Assist Correction] If you click [Exec] when the control assistance display does not match the actual camera angle, an operation is performed which confirms the actual camera angle, and the position of the control assistance display is automatically corrected. Correction takes approximately one minute. (10) [Camera Settings] Operate the focus. (11) Digital Zoom Range Displayed when [Digital Zoom] is set to [Enable] in [Camera] > [Camera] > [Camera Control] on the Setting Page. (12) [Zoom] Slider Click on the slider or drag the slider to zoom the camera. (13) [Control Assist Display] Button Switch whether to display control assist in the video display area. (14) [Apply] Click [Apply] to apply the changed settings. (15) [Clear] Click [Clear] to revert to the previous settings. Setting the Camera Angle and Zoom You can set the camera angle and zoom using the video display area or buttons. Important If you change the camera angle after configuring the intelligent function, privacy mask, preset, and ADSR, those settings must be configured again.  Configuring the Settings with the Operation Buttons and Sliders Set the angle and zoom using the [Pan], [Tilt], [Zoom], and [Rotation] buttons. These buttons operate while pressed and stop when released. Pans left or right. Tilts up or down. Operate the zoom ratio (telephoto/wide-angle). To operate with the [Zoom] slider, drag the slider to change the camera zoom ratio according to the position on the slider. If you set [Digital Zoom] to [Enable] in [Camera] > [Camera] > [Camera Control] on the Setting Page, the digital zoom area (yellow) is displayed and digital zoom becomes available. The higher the digital zoom ratio, the lower the video quality becomes. 48