Cisco AIR-BR1310G-A-K9 Hardware Installation Guide - Page 74
Manually Configuring Controller Information Using the Access Point CLI, Connecting to the Console - r console commands
UPC - 746320927565
View all Cisco AIR-BR1310G-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Manually Configuring Controller Information Using the Access Point CLI Chapter 5 Troubleshooting Lightweight Access Points Manually Configuring Controller Information Using the Access Point CLI In a new installation, when your access point is unable to reach a DHCP server, you can manually configure needed controller information using the lightweight access point CLI. Note The CLI commands in this section can be used only on a lightweight access point that is not associated to a controller. The static information configured with the CLI commands are used by the lightweight access point to connect with a controller. After connecting with the controller, the controller reconfigures the access point with new controller settings, but the static IP addresses for the access point and the default gateway are not changed. Connecting to the Console Serial Port If you need to configure the access point locally (without connecting to a wired LAN), you can connect a PC to the power injector console serial port using a DB-9 to RJ-45 serial cable. Follow these steps to open the CLI by connecting to the console serial port: Step 1 Connect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45 serial port on the power injector and to the COM port on your PC. Figure 5-3 shows the power injector's console serial port connector. Figure 5-3 Console Serial Port Connector 117188 CISCPOOWAERIRINOJENCTEORT 1 1 Console serial port connector (RJ-45 connector) Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide 5-6 OL-5048-06