Cisco AIR-BR1310G-A-K9 Hardware Installation Guide - Page 93
Access Point Specifications
UPC - 746320927565
View all Cisco AIR-BR1310G-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
C A P P E N D I X Access Point Specifications This appendix provides technical specifications for the access point/bridge, power injector, and power module. Table C-1 lists the technical specifications. Table C-1 Access Point, Power Injector, and Power Module Specifications Category Size LEDs Connectors Operating temperature Non-operational temperature Humidity Access Point Power Injector and Power Module Integrated antenna configuration: Power injector: 8.00 in. W x 8.10 in. H 2.62 in. D (20.32 cm W x 20.57 cm H 6.66 cm D) 4.62 in. W x 4.76 in. H x 1.07 in. D (11.74 cm W x 12.09 cm H x 2.72 cm D) Power module: 3.88 in. L x 1.24 in. W x 2.17 in. D (98.5 mm L x 31.4 mm W x 55.0 mm D) Four LEDs on the back panel: Radio (R), Ethernet One bi-color power LED on the side panel (E), Status (S), and Install (I). Bottom panel (left to right): Power injector dual-coax ports (two F-type connectors) and two reverse-TNC antenna connectors -22 to 131oF (-30 to 55oC) Po Side panel (left to right): Two coaxial uplink F-type connectors, 48-VDC power connector, RJ-45 connector for 100BASE-T Ethernet, and a RJ-45 serial console port connector wer injector: -22 to 131oF (-30 to 55oC) -40 to 185oF (-40 to 85oC) Po Power module: 32 to 104oF (0 to 40oC) wer injector: -40 to 185oF (-40 to 85oC)) Power module: -40 to 185oF (-40 to 85oC) (10,000 ft. limit) 0 to 90% (condensing) Power injector: 0 to 90% (non-condensing) Power module: 0 to 95% (non-condensing) OL-5048-06 Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide C-1