Cisco WS-C1912-A Hardware Installation Guide - Page 94
DETAILED STEPS, Examples
UPC - 746320021522
View all Cisco WS-C1912-A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Performing the Initial Configuration on the Router Chapter 5 Configuring the Router DETAILED STEPS Command or Action Step 1 enable Step 2 Example: Router> enable ping [ip-address | hostname] Step 3 Example: Router# ping 172.16.74.5 telnet {ip-address | hostname} Example: Router# telnet 10.20.30.40 Purpose Enables privileged EXEC mode. • Enter your password if prompted. Diagnoses initial network connectivity. • To verify connectivity, ping the next hop router or connected host for each configured interface. Logs in to a host that supports Telnet. • If you want to test the vty line password, perform this step from a different network device, and use your router's IP address. Examples The following display shows sample output for the ping command when you ping the IP address 192.168.7.27: Router# ping Protocol [ip]: Target IP address: 192.168.7.27 Repeat count [5]: Datagram size [100]: Timeout in seconds [2]: Extended commands [n]: Sweep range of sizes [n]: Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 192.168.7.27, timeout is 2 seconds: !!!!! Success rate is 100 percent, round-trip min/avg/max = 1/2/4 ms 5-20 Cisco 1900 Series Hardware Installation OL-19084-02