Compaq Presario V2000 Getting Started - Page 5
Hardware Setup - drivers
View all Compaq Presario V2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
1 Hardware Setup During hardware setup, you will 1. Identify the hardware you need to set up the notebook. 2. Insert the battery pack into the notebook, so the battery can begin to charge as soon as the notebook is connected to external power. 3. Connect the modem, so you will be able to register the notebook and operating system during software setup. 4. Connect the notebook to external power. 5. Open the notebook. 6. Turn on the notebook. When the notebook is turned on, you will be prompted to begin software setup. Ä CAUTION: To prevent file corruption and ensure that the correct drivers are installed: ■ Do not set up the notebook for the first time while the notebook is docked in an optional Expansion Base. (The Expansion Base can be used only with select models.) ■ During the hardware and software setup procedures: ❏ Do not unplug the notebook from external power. ❏ Do not shut down the notebook or initiate Standby or Hibernation. ❏ Do connect your modem as instructed in the "Step 3: Connect the Modem" section later in this chapter, but do not insert, remove, connect, or disconnect any other device, cable, or cord. Getting Started 1-1