Craftsman 28974 Operation Manual - Page 30

Rea De Trai

Page 30 highlights

immediately prepare your tractor for storage at the end of the season or if the trac- will not be used for 30 days or more. WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure. TRACTOR When tractor is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area. 1. Clean entire tractor (See "CLEANING" in the Maintenance section of this manual). 2. Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual). 3. Lubricate as shown in the Maintenance section of this manual. 4. Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary. 5. Touch up all rusted or chipped paint surfaces; sand lightly before painting. BATTERY acids during storage. Acidic gas can damage the fuel system of an engine while in storage. , Empty the fuel tank by starting the en- gine and letting it run until the fuel lines and carburetor are empty. • Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. , Use fresh fuel next season. NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least I0 minutes after adding stabilizer to allow the stabilizer to reach the carbure- tor. Do not empty the gas tank and carburetor if using fuel stabilizer. ENGINE OIL Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual). CYLINDER(S) 1. Remove spark plug(s). 2. Pour one ounce of oil through spark plug hole(s) into cylinder(s). 3. Turn ignition key to start position for a few seconds to distribute oil. , Fully charge the battery for storage. • After a period of time in storage, battery may require recharging. • To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected and batter/cleaned thoroughly (see "TO CLEAN BATTERY AND TERMINALS" in the Maintenance section of this manual). • After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals. , If battery is removed from tractor for storage, do not store batter,i directly on concrete or damp surfaces. ENGINE 4. Replace with new spark plug(s). OTHER o Do not store gasoline from one season to another. • Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems. , if possible, store your tractor indoors and cover it to give protection from dust and dirt. • Cover your tractor with a suitable protective cover that does not retain mois- ture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust. IMPORTANT: Never cover tractor while engine and exhaust areas are still warm. FUEL SYSTEM IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Also, alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of 30 INSTALE LA DE TRANSIV Para obtener n a este procedi[ MONTAJE DE REA DE TRAI_ Asegt_rese de superficie nivel 1. Haga desc posici6n m _, CUIDADO: resorte. Suj6t[ ientamente y t= 2. Haga girar hacia ta iz( lado derec tora hacia 3. Quite la cir correa, j&l_ caje bien e de ta corta NOTA: Cercid pensi6n de los dirigidos hacia debajo del trac 4. Deslice la hasta que t 5. INSTALE I ANCEO (_

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72

immediately
prepare
your
tractor
for stor-
age
at the
end of the season
or if the trac-
will
not be used for
30 days
or
more.
WARNING:
Never
store
the tractor
with
gasoline
in the tank
inside
a building
where
fumes
may
reach
an open
flame
or spark.
Allow
the engine
to cool
before
storing
in any enclosure.
TRACTOR
When
tractor
is to be stored
for a period
of time,
clean
it thoroughly,
remove
all dirt,
grease,
leaves,
etc.
Store
in a clean,
dry
area.
1.
Clean
entire
tractor
(See "CLEANING"
in the Maintenance
section
of this
manual).
2.
Inspect
and replace
belts,
if necessary
(See
belt replacement
instructions
in
the
Service
and Adjustments
section
of
this
manual).
3.
Lubricate
as shown
in the
Maintenance
section
of this
manual.
4.
Be sure
that all nuts,
bolts
and
screws
are securely
fastened.
Inspect
moving
parts
for
damage,
breakage
and wear.
Replace
if necessary.
5.
Touch
up all rusted
or chipped
paint
surfaces;
sand
lightly
before
painting.
BATTERY
,
Fully
charge
the battery
for storage.
After
a period
of time
in storage,
battery
may
require
recharging.
To help
prevent
corrosion
and
power
leakage
during
long
periods
of storage,
battery
cables
should
be disconnected
and
batter/cleaned
thoroughly
(see
"TO
CLEAN
BATTERY
AND
TERMINALS"
in
the Maintenance
section
of this
manual).
After
cleaning,
leave
cables
discon-
nected
and
place
cables
where
they
cannot
come
in contact
with
battery
terminals.
,
If battery
is removed
from
tractor
for
storage,
do not store
batter,i
directly
on
concrete
or damp
surfaces.
ENGINE
FUEL
SYSTEM
IMPORTANT:
It
is important
to
prevent
gum
deposits
from
forming
in essential
fuel
system
parts
such
as carburetor,
fuel
hose,
or tank
during
storage.
Also,
alcohol
blended
fuels
(called
gasohol
or using
ethanol
or methanol)
can attract
moisture
which
leads
to separation
and formation
of
30
acids
during
storage.
Acidic
gas can dam-
age the fuel system
of an engine
while
in
storage.
,
Empty
the fuel tank
by starting
the en-
gine
and
letting
it run until
the fuel
lines
and
carburetor
are empty.
Never
use engine
or carburetor
cleaner
products
in the fuel tank
or permanent
damage
may occur.
,
Use fresh
fuel next
season.
NOTE:
Fuel stabilizer
is an acceptable
alternative
in minimizing
the formation
of
fuel gum
deposits
during
storage.
Add
stabilizer
to gasoline
in fuel tank
or stor-
age
container.
Always
follow
the mix
ratio
found
on stabilizer
container.
Run
engine
at least
I0
minutes
after
adding
stabilizer
to allow
the stabilizer
to reach
the carbure-
tor.
Do not empty
the gas tank
and
carbu-
retor
if using
fuel stabilizer.
ENGINE
OIL
Drain
oil (with
engine
warm)
and
replace
with
clean
engine
oil.
(See
"ENGINE"
in
the Maintenance
section
of this
manual).
CYLINDER(S)
1.
Remove
spark
plug(s).
2.
Pour
one
ounce
of oil through
spark
plug
hole(s)
into cylinder(s).
3.
Turn
ignition
key to start
position
for a
few seconds
to distribute
oil.
4.
Replace
with
new
spark
plug(s).
OTHER
o Do not store
gasoline
from
one season
to another.
Replace
your
gasoline
can if your
can
starts
to rust.
Rust
and/or
dirt in your
gasoline
will
cause
problems.
,
if possible,
store
your
tractor
indoors
and cover
it to give
protection
from
dust
and dirt.
Cover
your
tractor
with
a suitable
pro-
tective
cover
that
does
not
retain
mois-
ture.
Do not use plastic.
Plastic
cannot
breathe
which
allows
condensation
to
form
and
will cause
your
tractor
to rust.
IMPORTANT:
Never
cover
tractor
while
engine
and exhaust
areas
are still warm.
INSTALE
LA
DE
TRANSIV
Para obtener n
a este procedi[
MONTAJE DE
REA DE TRAI_
Asegt_rese de
superficie nivel
1.
Haga desc
posici6n m
_,
CUIDADO:
resorte.
Suj6t[
ientamente
y t=
2.
Haga girar
hacia ta iz(
lado derec
tora hacia
3.
Quite la cir
correa, j&l_
caje bien e
de ta corta
NOTA:
Cercid
pensi6n de los
dirigidos hacia
debajo del trac
4.
Deslice la
hasta que t
5.
INSTALE I
ANCEO (_