D-Link DXS-3600-EM-STACK Hardware Installation Guide - Page 24

DXS-3600 Series 10GbE Layer 2/3 Switch Hardware Installation Guide DXS-3600-32S>enable DXS-3600-32S#configure terminal DXS-3600-32S(config)#username NewUser password 12345 DXS-3600-32S(config)#username NewUser privilege 15 DXS-3600-32S(config)#line console DXS-3600-32S(config-line)#login local DXS-3600-32S(config-line)#end DXS-3600-32S# Figure 4-5 To create a user account 1 At the CLI command prompt, enter the command 'enable' to enter the Privileged EXEC Mode. Press Enter. 2 Enter the command 'configure terminal' to enter the Global Configuration Mode. Press Enter. 3 Enter the command 'username NewUser password 12345'. Press Enter. This will create a user account with the username of 'NewUser' and a password of '12345'. 4 Enter the command 'username NewUser privilege 15'. Press Enter. This will configure this user account to have Administrative (15) privileges. 5 Enter the command 'line console' to enter the Line Configuration Mode. Press Enter. 6 Enter the command 'login local'. Press Enter. This specifies that the local line requires login credentials. 7 Enter the command 'end' to exit back to the Privileged EXEC Mode. NOTE: Passwords are case sensitive. Usernames can be up to 19 characters in length. Passwords can be up to 16 characters in length. Configuring the IP Address Each switch must be assigned its own IP Address, which is used for communication with an SNMP network manager or other TCP/IP applications. The switch's default IP address is 0.0.0.0 and should thus be configured prior to installation. You can change the switch's default IP address to fit into your networking address range. The Switch is also assigned a unique MAC address by the factory. This MAC address cannot be changed, and can be found by entering the command "show system-info" into the command line interface in the Privileged EXEC mode, as shown below. DXS-3600-32S#show system-info Device Type MAC Address IP Address VLAN Name Subnet Mask Default Gateway Boot PROM Version Firmware Version Hardware Version Firmware Type Serial Number System Name System Location System Uptime System Contact : DXS-3600-32S TenGigabit Ethernet Switch : B8-A3-86-12-02-B0 : 0.0.0.0 (Manual) : default : 0.0.0.0 : 0.0.0.0 : Build 1.10.007 : Build 1.10.023 : B1 : EI : R3F71C2000028 : : : 0 days, 0 hours, 8 minutes, 10 seconds : DXS-3600-32S# Figure 4-6 The 'show system-info' command The IP address of the Switch must be configured before it can be managed, by the user, via the Web User Interface. 18