Dell Alienware Area-51 R4 Service Manual - Page 22
Replacing the stability foot, Procedure
View all Dell Alienware Area-51 R4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Replacing the stability foot NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/ regulatory_compliance. Procedure 1. Tilt the computer towards the front until the base is facing up. 2. Align the screw holes on the stability foot with the screw holes on the base of the computer and replace the two screws (#6-32x6). 3. Tilt the computer back to the upright position. 22
Replacing the stability foot
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your computer
. After working inside your computer, follow the instructions in
After working
inside your computer
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance
.
Procedure
1.
Tilt the computer towards the front until the base is facing up.
2.
Align the screw holes on the stability foot with the screw holes on the base of the computer and replace the two screws
(#6-32x6).
3.
Tilt the computer back to the upright position.
22