Dell Alienware m17 R2 Service Manual - Page 25
Display assembly, Removing the display assembly
View all Dell Alienware m17 R2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Steps 1. Push the rear I/O-cover into the palm-rest assembly snapping it into place. NOTE: To avoiding damaging your computer, ensure the Tron light cable is not pinched and that the Mylar is pasted on the system board before snapping the rear I/O-cover into place. 2. Replace the two screws (M2.5x5) that secure the rear I/O-cover to the palm-rest assembly. 3. Peel and lift the Mylar from the system board. 4. Route the Tron light cable through the slot on the Mylar. 5. Connect the Tron light cable to the system board. 6. Route and adhere the Tron light cable into place on the system board. 7. Adhere the Mylar into place onto the system board. Next steps 1. Install the base cover. 2. Follow the procedure in After working inside your computer. Display assembly Removing the display assembly Prerequisites 1. Follow the procedure in Before working inside your computer. 25