Dell Alienware m17 R2 Service Manual - Page 53
Installing the power-button assembly, Prerequisites, About this task, Steps, Next steps
View all Dell Alienware m17 R2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Installing the power-button assembly Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the power-button assembly and provides a visual representation of the installation procedure. Steps 1. Place the power-button assembly and its cable in the slot on the palm-rest assembly. 2. Place the power-button bracket on the power-button assembly. 3. Connect the power-button assembly cable to the left I/O-board and close the connector latch. 4. Replace the three (M2x1.9) screws that secure the power-button bracket to the palm-rest assembly. 5. Adhere the power-button assembly cable on the palm-rest assembly. Next steps 1. Install the system board. 2. Install the battery. 3. Install the rear I/O-cover. 4. Install the 2230 solid-state drive. (if applicable) 5. Install the 2280 solid-state drive. (if applicable) 6. Install the base cover. 7. Follow the procedure in After working inside your computer. 53