Dell Dimension 8400 Owner's Manual - Page 92
Installing a Hard Drive
View all Dell Dimension 8400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
www.dell.com | support.dell.com Installing a Hard Drive 1 Unpack the replacement hard drive, and prepare it for installation. 2 Check the documentation for the drive to verify that it is configured for your computer. 3 If your replacement hard drive does not have the bracket rails attached, remove the rails from the old drive by removing the two screws that secure each rail to the drive. Attach the bracket rails to the new drive by aligning the screw holes on the drive with the screw holes on the bracket rails and then inserting and tightening all four screws (two screws on each rail). drive bracket rails (2) screws (4) 4 Install the hard drive into the computer by gently sliding the drive into place until you hear it securely click. 5 Connect the power and data cable to the drive and to the system board (see page 71). 92 Removing and Installing Parts