Dell Latitude CPi A User Manual - Page 39

Module Latch Assemblies, Orient each speaker in the bottom case so that its wires are facing upwards.

Get Dell Latitude CPi A PDF manuals and user guides View all Dell Latitude CPi A manuals
Add to My Manuals
Save this manual to your list of manuals

Page 39 highlights

NOTE: When you replace the bottom case bracket, follow these guidelines to prevent damage to the speaker wires: Orient each speaker in the bottom case so that its wires are facing upwards. Route the speaker wires under their respective retaining clips on the bottom case bracket. plungers (2) module latch assemblies (2) springs (2) module latches (2) 1. Remove the bottom case bracket. 2. Remove the left latch from the outside of the bottom case by unsnapping the slider-spring assembly. Keep pressure applied to the slider-spring assembly while unsnapping the latch to prevent the slider-spring assembly from coming loose from the case. If the slider-spring assembly does come loose from the case: a. Carefully reinsert the spring onto the plunger on the slider, and reinstall the slider-spring assembly into the holding features on the inside of the case. Dell Latitude CPi A Service Manual 33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
Dell Latitude CPi A Service Manual
33
NOTE: When you replace the bottom case bracket, follow these guidelines to
prevent damage to the speaker wires:
±
Orient each speaker in the bottom case so that its wires are facing upwards.
±
Route the speaker wires under their respective retaining clips on the bottom
case bracket.
ÂôÄÀ¼º#²ÊÈ̺½¸¸¼¾¿À·¼¸
±²³´µ¶·Â#¹··Ã»!´É¶·9Á¾Î5·ÆÇǶ¼Èɲ¶Ç·Ê¶¼»ËÁÉ
1.
Remove the bottom case bracket.
2.
Remove the left latch from the outside of the bottom case by unsnapping
the slider-spring assembly.
Keep pressure applied to the slider-spring assembly while unsnapping the
latch to prevent the slider-spring assembly from coming loose from the case.
If the slider-spring assembly does come loose from the case:
a.
Carefully reinsert the spring onto the plunger on the slider, and reinstall
the slider-spring assembly into the holding features on the inside of the
case.
module latch
assemblies (2)
springs (2)
module latches (2)
plungers (2)
module latches (2)