Dell OptiPlex 7080 Small Form Factor Service Manual - Page 16
Side cover, Removing the side cover
View all Dell OptiPlex 7080 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Table 7. Screw list (continued) Component 3.5 in. hard-drive System board Screw type #6-32 #6-32 Quantity 4 8 Image Side cover Removing the side cover Prerequisites 1. Follow the procedure in before working inside your computer. NOTE: Ensure that you remove the security cable from the security-cable slot (if applicable). About this task The following images indicate the location of the side panels and provide a visual representation of the removal procedure. Steps 1. Slide the release latch to the right until your hear a click and slide the cover towards the back of the system. 2. Lift the side cover from the system. Installing the side cover Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the side panel and provides a visual representation of the installation procedure. Steps 1. Place the side cover onto the system aligning the tabs on the chassis. 2. Slide the side cover towards the front of the system until you hear the release latch click. Next steps 1. Follow the procedure in after working inside your computer. 16 Field service information