Dell OptiPlex 7080 Small Form Factor Service Manual - Page 44

Installing the power-supply unit

Get Dell OptiPlex 7080 Small Form Factor PDF manuals and user guides View all Dell OptiPlex 7080 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals

Page 44 highlights

Steps 1. Remove the SATA cables from the retention clip on the support bracket. 2. Remove the two screws (M6X32) and slide the support bracket out from the slot. 3. Unroute the power-supply cable from the retention clip on the chassis. 4. Remove the three screws (M6X32) that secure the power-supply unit to the back of the chassis. 5. Press the power-supply unit release latch and slide the unit into the chassis. 6. Remove the power-supply unit out of the chassis. Installing the power-supply unit Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the power-supply unit and provides a visual representation of the installation procedure. 44 Field service information

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
Steps
1.
Remove the SATA cables from the retention clip on the support bracket.
2.
Remove the two screws (M6X32) and slide the support bracket out from the slot.
3.
Unroute the power-supply cable from the retention clip on the chassis.
4.
Remove the three screws (M6X32) that secure the power-supply unit to the back of the chassis.
5.
Press the power-supply unit release latch and slide the unit into the chassis.
6.
Remove the power-supply unit out of the chassis.
Installing the power-supply unit
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power-supply unit and provides a visual representation of the installation
procedure.
44
Field service information