Denon AVR 1909 Owners Manual - English - Page 31

Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifications Step 5 : Store F Menu screen F q Auto Setup Audyssey MultEQ Step5:Store Auto Setup Please select "Store" Audyssey MultEQ to store measurement Step5:Store values. Storing Please wait... Store Cancel ENGLISH Error Messages If the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the auto setup procedure over again. Error messages (examples) Auto Setup Audyssey MultEQ Caution! Microphone:None or Speaker :None Cause Measures • Included setup microphone is not connected. • Connect the included setup microphone to the SETUP MIC jack on the main unit. • Not all speakers could be detected. • Check the speaker connections. • The front L speaker was not properly detected. The auto setup measurement results are stored in the AVR-1909. q Select "Store 0", then press o. • "Storing Please wait..." is displayed on the on-screen display while the results are being stored. • When storing is complete, "Storing complete. Auto Setup is now finished." is displayed on the on-screen display. w Disconnect the setup microphone from the AVR-1909. n To cancel storing Press ui to select "Cancel 0", then press o. • All the measured auto setup data will be erased. NOTE Do not turn the power off while the settings are being stored. Retry Cancel Auto Setup Audyssey MultEQ Caution! Ambient noise is too high or Level is too low. Retry Cancel Auto Setup Audyssey MultEQ Caution! Front R :None Retry Cancel Auto Setup Audyssey MultEQ Caution! Front L :Phase Retry Cancel Skip • Too much noise in the room for accurate • Either turn off any device generating noise or move it measurements to be made. away. • Try again when the surroundings are quieter. • Speaker or subwoofer sound is too low for • Check the speaker installation and the direction in accurate measurements to be made. which the speakers are facing. • Adjust the subwoofer's volume. • Displayed speaker could not be detected. • Check the connections of the displayed speaker. · The front R speaker were not properly detected. · Only one channel of the surround speakers was detected. · Sound was output from the R channel when only one surround back speaker was connected. · The surround back, but the surround speaker was not detected. • Displayed speaker connected with the • Check the polarities of the displayed speaker. polarities reversed. • For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure that the wiring is correct, select "Skip". Select "Retry" to measure again. NOTE Be sure to turn the power off before checking the speaker connections.