Denon AVR 1909 Owners Manual - English - Page 52

Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifications ENGLISH A4 SB CH Out (Selectable displays during 2-channel source playback.) Determine whether to use surround back speakers. [Selectable items] ON : The surround back channel signal is played. OFF : The surround back channel signal is not played. Tone Adjust the tonal quality of the sound. A7 Tone Control Turn tone adjustments off. [Selectable items] A5 SUBWOOFER ATT Attenuate subwoofer level when using EXT. IN mode. ON : Allow tone adjustment (treble, bass). OFF : Playback without tone adjustment. [Selectable items] ON : The input from the subwoofer channel is attenuated. OFF : The input from the subwoofer channel is not attenuated. Usually use in this mode. The tone cannot be adjusted when in the DIRECT mode. NOTE When the "Dynamic EQ" setting is "ON", setting is not possible. Set this to "ON" if the subwoofer channel level seems too high when playing audio signal. A6 Subwoofer Turn subwoofer output on and off. A8 Bass Adjust low frequency range (bass). [Variable range] -6dB ~ 0dB A9 Treble ~ +6dB [Selectable items] ON : The subwoofer is used. OFF : The subwoofer is not used. Adjust high frequency range (treble). [Variable range] -6dB ~ 0dB ~ +6dB "Bass" and "Treble" can be set when "Tone Control" is set to "ON". Audyssey Settings Select MultEQ, Dynamic EQ and Dynamic Volume. S0 MultEQ Select the type of correction desired from the following list: [Selectable items] Audyssey : Optimize frequency response of all speakers. Audyssey Byp. L/R : Optimize frequency response of speakers except front L and R speakers. Audyssey Flat : Optimize frequency response of all speakers to flat response. Manual : Apply frequency response set with "Manual EQ" (vpage 34). OFF : Turn equalizer off. Audyssey OFF Manual Audyssey Byp. L/R Audyssey Flat Operating from the main unit or main remote control unit Press MULTEQ. • When "Audyssey", "Audyssey Byp. L/R" or "Audyssey Flat" is selected, " " lights. • After running Auto Setup, if the Speaker Configuration, Distance, Channel Level, and Crossover Frequency have changed without increasing the number of speakers measured, only " " lights. • "Audyssey", "Audyssey Byp. L/R" and "Audyssey Flat" can be selected after the auto setup procedure has been performed. • After performing "Auto Setup", the "MultEQ" setting automatically becomes "Audyssey". • If the settings of speakers for which "None" has been determined at "Auto Setup" are changed, "Audyssey", "Audyssey Byp. L/R" and "Audyssey Flat" cannot be selected. Either perform Auto Setup again, or return to the setting after running Auto Setup with "Auto Setup" - "Parameter Check" - "Restore". • MultEQ and Manual EQ set to "Not Used" with "Manual Setup" - "Audio Setup" - "EQ Preset" - "EQ Customize" (vpage 34) on the menu, cannot be selected. • When using headphones, "MultEQ" is set to "OFF". 49 For details on adjusting individual parameters, see "Adjusting the parameters" (vpage 46).