Denon AVR 1909 Owners Manual - English - Page 66

Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifications ENGLISH Symbols used to indicate buttons in this manual Button located on both the main unit and the remote control unit BUTTON Button only on the main unit Button only on the remote control unit [BUTTON] ui QUICK SELECT , op QUICK SELECT [Front] [Rear] uiop uiop  [CH SELECT/ ENTER] [CH SELECT/ ENTER] Operations 1 Connect the HDMI to the AVR-1909 with equipment compatible with the HDMI control function (vpage 62). 2 Put the power on for all the equipment connected to the HDMI. 3 Check the settings for all the equipment connected to the HDMI and make HDMI available to them. b Please consult the operating instructions for the connected equipment to check the settings. b Steps 1~3 do not have to be repeated once started. b Carryout steps 2 and 3 should any of the equipment be plugged out. 4 Switch the television input to the HDMI connected to the AVR-1909. 5 Switch the AVR-1909 input to the HDMI input source and check if the picture from the player is ok. 6 Put the television power on standby and check if the AVR-1909 goes into standby. If the AVR-1909 does not work please check the following. • Is the menu "Manual Setup" - "HDMI Setup" - "HDMI Control" (vpage 32) set to "ON"? • Is the menu "Manual Setup" - "HDMI Setup" - "Power Off Control" (vpage 32) set to "ON"? • Is the control function used for the television HDMI properly set? (Check the television operating instructions for details.) • Should any of the operations below be performed, the interlocking function may be reset, in which case, repeat step's 2 and 3. • Menu "Input Setup" - "Assign" - "HDMI In" (vpage 42) setting has changed. • There is a change to the connection between the equipment and the HDMI, or an increase in equipment. NOTE When you power off AVR-1909, the HDMI control function does not operate. Either power on or set to standby. Channel Level You can adjust the channel level either according to the playback sources or to suit your taste, as described below. 1 Press or [CH SELECT / ENTER]. Channel Volume FL 0.0dB SR 0.0dB C 0.0dB SBR 0.0dB FR 0.0dB SBL 0.0dB SW 0.0dB SL 0.0dB Fader FRONT : REAR 2 Use ui, or [CH SELECT / ENTER] to select the speaker. The speaker that can be set switches each time one of the buttons is pressed. 3 Use o p to adjust the volume. b In the case of a subwoofer, reducing the volume when it is at "-12 dB" will change the setting to "OFF" (none). NOTE When the input source is "iPod", you cannot perform channel level setting. Fader Function This function lets you adjust (fade) the sound from all the front or rear speakers at once. 1 Press or [CH SELECT / ENTER]. 2 Press ui, or [CH SELECT / ENTER] to select "Fader". 3 Use o p to adjust the volume of the speakers. (o: front, p: rear) • The fader function does not affect the subwoofer. • The fader can be adjusted until the volume of the speaker adjusted to the lowest value is -12 dB.