Denon AVR 1909 Owners Manual - English - Page 49
Adjusting the parameters - audio return channel
UPC - 883795000444
View all Denon AVR 1909 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifications ENGLISH Operating from the main unit Use to select the surround mode. n During PCM (2ch) / Analog / DOLBY DIGITAL (2ch) DIRECT STEREO DOLBY PRO LOGIC gx (DOLBY PRO LOGIC g) 7CH STEREO neuralz DTS NEO:6 (5CH STEREO) ROCK ARENA JAZZ CLUB MONO MOVIE VIRTUAL MATRIX VIDEO GAME z : It is possible to play analog input signals and PCM (2-channel, 48 kHz or less) in the surround mode. n During Digital (Multi channel) DIRECT STEREO STANDARD (Dolby Digital, DTS, etc) ROCK ARENA 7CH STEREO (5CH STEREO) JAZZ CLUB MONO MOVIE VIRTUAL MATRIX VIDEO GAME Parameter Symbols used to indicate buttons in this manual Button located on both the main unit and the remote control unit BUTTON Button only on the main unit Button only on the remote control unit [BUTTON] RESTORER MULTEQ ui Playback in the PURE DIRECT Mode This is the mode that recreates the original sound most faithfully, providing extremely high quality sound. Press [PURE DIRECT]. • To cancel, press [PURE DIRECT] again. • When in the PURE DIRECT mode, the on-screen display is not displayed and the display on the main unit is turned off. • If the HDMI input connector is selected, video outputs are output in the PURE DIRECT mode. • The channel level and surround parameters in the PURE DIRECT mode are the same as in the DIRECT mode. DYNAMIC VOLUME RETURN ENTER, op [Front] uiop [AUDIO DELAY] DYNAMIC VOLUME [SOURCE CONTROL 1] ENTER [NIGHT] MULTEQ RESTORER [Rear] [CINEMA] [A. MENU] [MUSIC] [STANDARD] ENTER uiop RETURN Adjusting the parameters 1 Press or [A.MENU]. The menu is displayed. b To operate from the main remote control unit, be sure to set the [SOURCE CONTROL 1] to "AUDIO". 2 Use ui to select "Parameter", then press ENTER. 3 To change the setting: Press ui to select the item you want to change, then press o p to change the setting. b To return to the previous item, press RETURN. b Select "Default Yes", then press o to reset to the default setting. 4 Press ENTER to enter the setting. n To exit adjustment Press or [A.MENU] during adjustment.