Denon AVR 1909 Owners Manual - English - Page 62
Basic Operation, Searching Categories, Parental Lock - firmware update
UPC - 883795000444
View all Denon AVR 1909 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifications ENGLISH Symbols used to indicate buttons in this manual Button located on both the main unit and the remote control unit BUTTON Button only on the main unit Button only on the remote control unit [BUTTON] ui [Front] [OFF] [iPod] [1] [6, 7] [8, 9] uiop [SOURCE CONTROL 1] [Rear] [iPod] [TUNING+/-] [MODE] ENTER, op [2] ENTER [SOURCE CONTROL 2] uiop ENTER Searching Categories 1 Press [o p]. SR001 Hits 1 CAT : Pops Channel category 2 Use [o p] to select the category, then use [ui] to select the desired channel. • "UPDATING" is displayed while the encording code is being updated. • "SIRIUS UPDATING" is displayed when updating SIRIUS tuner firmware. • Refer to "Troubleshooting" - "SIRIUS Satellite Radio" regarding other messages (vpage 85). Parental Lock 1 Tune to the channel you want to lock. 2 Press [ENTER] for at least 3 seconds. "Code: [ ]" is displayed. 3 Enter the 4-digit lock code using uio p. When you enter the correct code, the corresponding channel is locked. 4 Press [ENTER]. iPod® Playback The music on an iPod can be played by using the control dock for iPod (ASD-1R, ASD-11R, ASD-3N or ASD-3W sold separately). The operation can also be performed using the buttons on the main unit or remote control unit while watching the menus. iPod is a trademark of Apple Inc., registered in the U.S. and other countries. b The iPod may only be used to copy or play contents that are not copyrighted or contents for which copying or playback is legally permitted for your private use as an individual. Be sure to comply with applicable copyright legislation. Basic Operation 1 Make the necessary preparations. qSet the iPod in the DENON control dock for iPod. (vSee the control dock for iPod's operating instructions.) wAssign the control dock for iPod's input. The input for the control dock for iPod is assigned to VCR by default. MENU : "Input Setup" - "Assign" - "iPod Dock" (vpage 42) 2 Either turn or press [iPod] to select the input source assigned in step 1-w above. • Channels under Parental Lock cannot be tuned in by performing Tuning Up/Down or by category search. • Channels stored in preset memory can be tuned in by the preset channel select operation, even if Parental Lock is applied. • When a channel to which Parental Lock is applied is being played, Parental Lock for that channel is cancelled by performing Step2. • See "Edit Lock Cord" (vpage 43) for the method of changing Parental Lock Cord. • You can also set "Parental Lock" from the menu (vpage 43). OK to disconnect. (iPod screen) b If the screens above are not displayed, the iPod may not be properly connected. Try connecting again. 3 Set [SOURCE CONTROL 1] to "AUDIO" and [SOURCE CONTROL 2] to "iPod/NETWORK". (vpage 65 "Remote Control Unit Operations")