Edimax EW-7428HCn Manual - Page 50
Input Client PIN
View all Edimax EW-7428HCn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Passphrase Key Device Configuration Config Mode Configure via Push Button Input Client PIN Code Shows the WPA passphrase here, though all characters will be replaced by asterisks for security reasons. If encryption is not set on this access point, this field will be blank. Configuration options for the device's WPS settings can be found here. There are "Registrar" and "Enrollee" modes for the WPS connection. When "Registrar" is enabled, the wireless clients will follow the access point's wireless settings for WPS connections. When "Enrollee" mode is enabled, the access point will follow the wireless settings of wireless client for WPS connections. Click "Start PBC" to start Push-Button style WPS setup. This access point will wait for WPS requests from wireless clients for 2 minutes. The "WLAN" LED on the access point will stay on for 2 minutes while this access point waits for incoming WPS requests. Please input the PIN code of the wireless client you wish to connect, and click the "Start PIN" button. The "WLAN" LED on the access point will stay on while this access point waits for incoming WPS requests. Note: When using PBC-type WPS setup, you must press the hardware or software WPS button on the wireless client within 120 seconds. If you do not do so in time, you will need to activate WPS on this access point again. 50