Electrolux EI30GF55GB Complete Owner's Guide (English) - Page 44

Setting self-clean, Setting delayed self-clean, IMPORTANT, NOTES - icon

Page 44 highlights

44 Self-Clean Setting self-clean Setting delayed self-clean The clean feature provides 3 different choices for self-cleaning the upper oven. Set the clean forlite (2 hrs), med (3 hrs) or heavy soils (4 hrs). The example below shows setting the upper oven for self-clean to begin immediately using a medium (3 hour) setting. Step Example Press You may wish to set your appliance to perform a self-clean cycle sometime later (up to 12 hours later). The END TIME key will determine when the cleaning will stop. You will need to set theEND TIME out far enough to allow for the type of clean cycle you choose (2-34 hours). Remember to add 30-40 additional minutes for the oven to cool enough and the oven door to unlock. 1. Remove racks and Press UPPER OVEN The example below shows setting the upper oven for a self-clean cycle to end at 8:00 o'clock. 2. Choose LITE, MED OR HEAVY CLEAN or or Example 3. Press START After pressing start, the motorized oven door latch will automatically lock the door. The DOOR lock icon will flash (Fig. 1). Once the door has locked the DOOR lock icon will remain on through the entire self-clean cycle. After self-clean, the oven may take about 30-40 minutes to cool and unlock. AHot message (Fig. 2) will display during this period. After cooling the DOOR lock icon will flash and disappear indicating that the door has unlocked. Step 1. Remove racks and Press UPPER OVEN 2. Choose LITE, MED OR HEAVY CLEAN 3. Press END TIME 4. Enter 800 Press or or 5. Press START Fig. 1 Fig. 2 IMPORTANT • A self-clean cycle will not start if the appliance has the CONTROL LOCK turned on. • If a self-clean cycle was started but did not finish due to a power failure, your oven may not be completely cleaned. After power has been restored and the oven door has unlocked, set for another self-clean if needed. NOTES Example • You may press CANCEL any time during the cleaning process. After cancelling the selfclean cycle, do not attempt to open the oven door until the DOOR lock icon turns off. • If you desire to set a delayed self-clean cycle to end in 12-24 hours, use theUSER PREF key to set the 12hr energy saving mode (ES) to OFF and also set the clock mode (CLO) to 24 hr. Example

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56

44
Self-Clean
Setting self-clean
The clean feature provides 3 different choices for
self-cleaning the upper oven. Set the clean for
lite
(2 hrs),
med
(3 hrs) or
heavy
soils (4 hrs). The
example below shows setting the upper oven for
self-clean to begin immediately using a medium (3
hour) setting.
or
or
2.
Choose
LITE, MED OR
HEAVY CLEAN
1.
Remove racks and
Press
UPPER OVEN
3.
Press
START
Example
2.
Choose
LITE, MED OR
HEAVY CLEAN
1.
Remove racks and
Press
UPPER OVEN
5.
Press
START
Example
3.
Press
END TIME
4.
Enter
800
Setting delayed self-clean
You may wish to set your appliance to perform a
self-clean cycle sometime later (up to 12 hours
later). The
END TIME
key will determine when the
cleaning will stop.
You will need to set the
END TIME
out far enough
to allow for the type of clean cycle you choose (2-3-
4 hours). Remember to add 30-40 additional
minutes for the oven to cool enough and the oven
door to unlock.
The example below shows setting the upper oven
for a self-clean cycle to end at 8:00 o’clock.
After pressing start, the motorized oven door latch
will automatically lock the door
. The DOOR lock
icon will flash (Fig. 1). Once the door has locked the
DOOR lock icon will remain on through the entire
self-clean cycle.
After self-clean, the oven may take about 30-40
minutes to cool and unlock.
A
Hot
message (Fig. 2)
will display during this period. After cooling the
DOOR lock icon will flash and disappear indicating
that the door has unlocked.
IMPORTANT
A self-clean cycle will not start if the appliance
has the CONTROL LOCK turned on.
If a self-clean cycle was started but did not
finish due to a power failure, your oven may
not be completely cleaned. After power has
been restored and the oven door has
unlocked, set for another self-clean if needed.
Example
Step
Press
Step
Press
Fig. 2
Fig. 1
NOTES
You may press
CANCEL
any time during the
cleaning process. After cancelling the self-
clean cycle, do not attempt to open the oven
door until the DOOR lock icon turns off.
If you desire to set a
delayed self-clean
cycle to end in 12-24 hours, use the
USER
PREF
key to set the 12hr energy saving mode
(ES) to OFF and also set the clock mode
(CLO) to 24 hr.
or
or