Epson 6100i Operation Guide - EMP Monitor v4.22 - Page 33

An e-mail notifying the operator of a problem/warning/status is issued 32 If the projector experiences a problem or enters a status requiring attention, an e-mail like that shown below is sent to the address specified for "Recipient mail address". If there is more than one problem, warning, or status, the corresponding messages are output to separate lines. Item Details shown E-mail subject [Display name displayed in "Grouping view" or "Detail list view"] Projector status notification Body has entered the following status. The details contained in the e-mail message can consist of the following. Message Internal Error Remedy See your User's Guide for more information. Fan error Sensor error Lamp Cover Open Lamp failure at power on Lamp Error High internal temperature error Low air flow error Air filter air flow sensor error Message High-temperature warning Remedy See your User's Guide for more information. Replace Lamp Replace Air Filter No Air Filter Low Air Flow Air Flow Sensor Err. Clean Air Filter Notice No signal No image signals are being received by the projector. Check the connection status and check that the power for the connected equipment is turned on. Other error Supply System Error (Ballast) Auto Iris Error Stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. Network error (TCP connection error) Check that the projector's power is turned on and the LAN cable is connected, and also check that "Network Monitoring" is set to "ON" or "Standby Mode" is set to "Network ON". Network error (ESC/ VP.net communication error) Check that the projector has been correctly connected to the network. Network error (monitor Check the projector's Monitor Password. password authentication error) Messages to inform that the projector has recovered from the error or warning statuses are sent.