Epson 6100i Operation Guide - EasyMP Monitor v4.40 - Page 31

Monitoring window layout 31 Lamp error (Lamp 2) Lamp failure at power on (Lamp 2) Replace Air Filter Low Air Flow Supply System Error (Ballast 1) Cinema filter warning Lamp Cover Open Lamp Error (Lamp 1) Lamp failure at power on Lamp failure at power on (Lamp 2) Low air flow error Internal Error Sensor error Supply System Error (Ballast 1) Auto Iris Error Shutter error Cooling system error (pump) Lamp failure at power on (Lamp 1) High-temperature warning No Air Filter Air Flow Sensor Err. Supply System Error (Ballast 2) Shutter warning Lamp Error Lamp Error (Lamp 2) Lamp failure at power on (Lamp 1) High internal temperature error Air filter air flow sensor error Fan error Supply System Error (Ballast) Supply System Error (Ballast 2) Cinema filter error Cooling system error (Peltier element) Other error *1 When Temperature level display group view is set to On at Environment setup in the Tool menu, an icon indicating the internal temperature of the projector will be displayed on top of the projector icon. The default setting is Off. *2 Check the following items. - Check that the projector's power is turned on. - Check that the LAN cable is connected. - Check that Standby Mode is set to Communication On (or Network On) or Network Monitoring is set to On in the projector's configuration menu. *3 Check that the projector has been correctly connected to the network. *4 It describes DVI-D if the projector is equipped with both DVI-D and HDMI input terminal. *5 It describes HDMI if the projector is equipped with both DVI-D and HDMI input terminal. *6 You can display Replace Lamp at any time preset at Environment setup in the Tool menu. q Detectable error information differs with the projector you are using. Checking properties in detail You can check the properties of Group and projectors in detail. Displaying Group properties Procedure You can use either of the following methods to display the properties. • Displaying the properties for all groups in Grouping view Right-click in Grouping view and select Property.