Epson 6100i Operation Guide - EasyMP Monitor v4.40 - Page 41

E-mail notification 41 The details contained in the e-mail message can consist of the following. Message Internal Error Fan error Sensor error Lamp Cover Open Lamp failure at power on* Lamp Error* Supply System Error (Ballast)* High internal temperature error Low air flow error Air filter air flow sensor error Cinema filter error Shutter error Cooling system error (Peltier element) Cooling system error (pump) High-temperature warning Replace Lamp* Lamp error* Lamp failure at power on* Supply System Error (Ballast)* Replace Air Filter No Air Filter Low Air Flow Air Flow Sensor Err. Remedy See your projector User's Guide Message Cinema filter warning Shutter warning Clean Air Filter Notice No signal Other error Auto Iris Error Network error (TCP connection error) Network error (ESC/VP.net communication error) Network error (Monitor Password authentication error) Remedy See your projector User's Guide No image signals are being received by the projector. Check the connection status and check that the power for the connected equipment is turned on. Stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. Check the following items. Check that the projector's power is turned on. Check that the LAN cable is connected. Check that Standby Mode is set to Communication On (or Network On) or Network Monitoring is set to On in the projector's configuration menu. s Projector's User's Guide Check that the projector has been correctly connected to the network. s Projector's User's Guide Check the projector's Monitor Password. * When the projector has 2 lamps, the additional information, such as (Lamp 1) or (Ballast 1), is displayed after the message so that you can know which lamp has problems/warnings.