Epson Stylus Pro 9000 Service Manual - Page 69
Maintenance Assembly Removal & Disassembly, Maintenance Procedures, Maintenance Cover, Removal
View all Epson Stylus Pro 9000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
EPSON Stylus Pro 9000 MAINTENANCE ASSEMBLY REMOVAL & DISASSEMBLY When replacing the Waste Ink Pads, you also have to replace other parts (see Maintenance Procedures on page 67). Refer to the steps below to replace the following: Right Flushing Box Pump Mechanism Capping Mechanism Head Cleaning Blade Preparation: Remove the Maintenance Cover as described in Maintenance Cover Removal on page 58. Remove the Top Cover as described in Top Cover Removal on page 59. Remove the Right Side Cover as described in Left and Right Side Cover Removal on page 60. Remove the Lower Paper Guide as described in Lower Paper Guide Removal on page 63. Remove the right-side Waste Ink Box as described in Replacing the Waste Ink Pads on page 67. 1. Disconnect CN9 and CN19 from the relay board on the right side of the printer. See Figure 4-21. 2. Remove two screws (CP(W2) M4x6) securing the Maintenance Assembly to the printer as shown below. Access the screws from underneath the Maintenance Assembly. (The screw on the right is hidden, so you may have to get down very low to see it.) Two screws (the one on the right is hidden) Figure 4-20. Maintenance Assembly Removal - 1 Disassembly & Assembly 69