Epson TM T88II User Manual - Page 46
Parallel interface specifications, Set 1, Print Density Selection
View all Epson TM T88II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Parallel interface specifications Set 1 SW 1-1 1-2 1-3~ 1-8 Function Auto line feed Receive buffer capacity ON Always enabled 45 bytes Undefined - OFF Always disabled 4K bytes - Set 2 SW 2-1 2-2 2-3 2-4 2-5~ 2-7 2-8 Function ON OFF Handshaking (BUSY condition) • Receive buffer full • Reading data • Off-line • Receive buffer full • Reading data Reserved (Do not change settings) Fixed to Off Selects print density Refer to table below Reserved (Do not change settings) Fixed to Off I/F pin 31 reset signal (Do not change settings) Fixed to On Print Density Selection Print Density 1 Low power consumption mode 2 (Normal) 3 4 (Dark) SW 2-3 ON OFF ON OFF SW 2-4 ON ON OFF OFF A-4 DIP Switch and Paper Near End Settings
A-4
DIP Switch and Paper Near End Settings
Parallel interface specifications
Set 1
Set 2
Print Density Selection
SW
Function
ON
OFF
1-1
Auto line feed
Always enabled
Always disabled
1-2
Receive buffer capacity
45 bytes
4K bytes
1-3~
1-8
Undefined
—
—
SW
Function
ON
OFF
2-1
Handshaking
(BUSY condition)
•
Receive buffer full
•
Reading data
•
Off-line
•
Receive buffer full
•
Reading data
2-2
Reserved
(Do not change settings)
Fixed to Off
2-3
Selects print density
Refer to table below
2-4
2-5~
2-7
Reserved
(Do not change settings)
Fixed to Off
2-8
I/F pin 31 reset signal
(Do not change settings)
Fixed to On
Print Density
SW 2-3
SW 2-4
1 Low power consumption mode
ON
ON
2 (Normal)
OFF
ON
3
ON
OFF
4 (Dark)
OFF
OFF