Fluke 724 Fluke 724 Users Manual - Page 36
Using Source Mode, Sourcing Electrical Parameters - process calibrator
View all Fluke 724 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
724 Users Manual Using Source Mode In SOURCE mode, the calibrator generates calibrated signals for testing and calibrating process instruments, supplies voltages and resistances, and simulates the electrical output of RTD and thermocouple temperature sensors. Sourcing Electrical Parameters Volts or ohms are sourced and shown in the lower display. To select an electrical sourcing function, proceed as follows: 1. Connect the test leads as shown in Figure 12, depending on the source function. M 2. If necessary, press for SOURCE mode. 3. Press V for dc voltage, or U for resistance. 4. Enter the desired output value by pressing X and W keys. Press Y and Z to select a different digit to change. V + - Red Black 30V MAX ALL TERMINALS SOURCE / MEASURE MEASURE 3W V TC V mA RTD LOOP 4W COM COM Common Figure 12. Electrical Sourcing Connections zi09f.eps 26