Hayward OmniLogic Installation Manual - Page 11

Temperature Sensors

Get Hayward OmniLogic PDF manuals and user guides View all Hayward OmniLogic manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Minimum Clearance between heatsink and mounting surface - 1/8" For Vinyl Siding - 3/8" Temperature Sensors Three sensors are included with the OmniLogic. A water sensor and an air sensor must be installed at all times for proper operation. A solar sensor is required if the solar function is enabled. Water Sensor This sensor is used to measure the pool/spa temperature and is installed in the filtration plumbing after the filter but before either the solar or conventionally fueled heaters-refer to the plumbing overview diagram. 1. Drill a 3/8" (10mm) diameter hole in the PVC piping and remove all chips and burrs. 2. Insert sensor until O-ring collar sits flush on the hole. 3. Position hose clamp over the sensor and gently tighten until O-ring makes an adequate seal. Do not overtighten. Air Sensor Mount the air sensor outdoors. IMPORTANT: The air sensor must not be mounted in direct sunlight. Solar Sensor For solar applications, mount the sensor near the solar collector array so that it is exposed to the same sunlight as the collectors. Use additional cable (20 AWG) if necessary. 7 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
7
Temperature Sensors
Three sensors are included with the OmniLogic.
A water sensor and an air sensor must be installed at all times for proper operation.
A solar sensor is required
if the solar function is enabled.
Water Sensor
This sensor is used to measure the pool/spa temperature and is installed in the filtration plumbing after the filter but before either the solar or conventionally
fueled heaters—refer to the plumbing overview diagram.
1.
Drill a 3/8” (10mm) diameter hole in the PVC piping and remove all chips and burrs.
2.
Insert sensor until O-ring collar sits flush on the hole.
3.
Position hose clamp over the sensor and gently tighten until O-ring makes an adequate seal.
Do not overtighten.
Air Sensor
Mount the air sensor outdoors.
IMPORTANT: The air sensor must not be mounted in direct sunlight.
Solar Sensor
For solar applications, mount the sensor near the solar collector array so that it is exposed to the same sunlight as the collectors.
Use additional cable (20 AWG)
if necessary.
Minimum Clearance between heatsink and mounting surface - 1/8”
For Vinyl Siding - 3/8”