Hayward OmniLogic Installation Manual - Page 5

Before you Begin What's Included Before attempting to install the OmniLogic system, check that the following components have been included in the package: • OmniLogic Electronics Unit • (3) Temperature sensors with 15 ft. (5m) cable, hose clamp What's NOT Included Some of the additional items that you may need to complete an installation include: Circuit breakers None are included with control-see page 14 and inside door label for suitable breakers Wire 4-conductor cable for connection to optional wired terminal(s) Wire/conduit for 125A service from main panel to OmniLogic Wire/conduit for filter pump and other high voltage loads Wire for remote heater control and other low voltage devices Wire for bonding Miscellaneous Optional utility electrical outlet and weatherproof cover (for mounting on side of OmniLogic) Mounting hardware (screws, bolts, etc.) for mounting OmniLogic and remote terminals Valve Actuators (to automate valve functions) Accessory Products - Order Separately T-CELL-3 Chlorinator Cell - generates chlorine for pools up to 15k gallons T-CELL-9 Chlorinator Cell - generates chlorine for pools up to 25k gallons T-CELL-15 Chlorinator Cell - generates chlorine for pools up to 40k gallons P-KIT Chlorination plumbing kit containing flow switch and cell unions HL-CHEM ORP & pH Sensing Kit for monitoring and controlling pool chemistry HLRELAYBANK Additional relay pack adds 4 high voltage relays HLIOEXPAND Input/Output Expander Board adds 4 additional sensor/external inputs, 4 heater/low voltage outputs, and 4 actuator outputs HLDIMMER Light Dimmer Relay Kit HLRELAY Single high voltage relay kit HLWLAN Wireless home network connectivity - eliminates the need to hard wire the OmniLogic to the home's router/access point HLWALLMOUNT Wired Wall Mount Remote Terminal GVA-24 Valve Actuator V&A-xx Valve & Actuator (xx=1P (1.5" pos. seal), -2P (2" pos. seal) NOTE: Before installing this product as part of a saline water purification system in a pool or spa using natural stone for coping or for immediately adjacent patios/decking, a qualified stone installation specialist should be consulted regarding the appropriate type, installation, sealant (if any) and maintenance of stone used around a saline pool with electronic chlorine generator in your particular location and circumstances. NOTE: The use of dry acid (sodium bisulfate) to adjust pool pH is discouraged especially in arid regions where pool water is subject to excessive evaporation and is not commonly diluted with fresh water. Dry acid can cause a buildup of by-products that can damage your chlorinator cell. Overview The OmniLogic HLBASE is a multifunction pool automation control that is expandable to meet all your needs and fully manage your pool/spa system. The OmniLogic can control pumps, valves, lighting, heaters, pool chemistry and more. It offers the next generation of technology to manage pool/spa equipment and the backyard experience. Using a touchscreen interface and network connectivity, the OmniLogic gives the user complete control over both automation and chlorination of their pool and spa. Although the OmniLogic is easy to use, it is important to completely read through this manual before attempting to install, configure or operate the unit. 1 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS