HP 200 HP StorageWorks 200 Storage Virtualization System site preparation guid - Page 41

European AC power cabling, European branch circuit requirements

Get HP 200 PDF manuals and user guides View all HP 200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 41 highlights

European AC power cabling The HP SVS200 rack requires 20-amp, single-phase 200 VAC power supplied by four power cords with plugs, four receptacles, and four main disconnect devices (circuit breakers). The HP SVS200 comes from the HP factory with the AC power cables and plugs or stripped ends you have ordered. Plug types are specified under the heading, AC inputs. The opposite end of the power cord connects to the HP SVS200 power distribution unit (PDU) input, which is a type IEC 320-C20 connector. European branch circuit requirements To protect the system, your building must be wired correctly. Each supply ("hot") conductor must be protected by a short-circuit protective device and by an overcurrent protective device. The table listed under AC inputs provides specifications for the overcurrent protective devices required for single-phase operation. All protective devices must comply with national standards of the country where the unit is to be installed. If a protective device interrupts any supply conductor, it must also interrupt all other supply conductors. Overcurrent protection is also required for the neutral conductor. Your electrician should know the appropriate code requirements for your location/site and wire power distribution to the HP SVS200 accordingly. HP StorageWorks 200 Storage Virtualization System site preparation guide 41

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
European AC power cabling
The HP SVS200 rack requires
20-amp, single-phase 200 VAC power
supplied by four power cords with
plugs, four receptacles, and four main disconnect devices (circuit breakers).
The HP SVS200 comes from the HP factory with the AC power cables and plugs or stripped ends you
have ordered. Plug types are speci
fi
ed under the heading,
AC inputs
. The opposite end of the power cord
connects to the HP SVS200 power distribution unit (PDU) input, which is a type IEC 320-C20 connector.
European branch circuit requirements
To protect the system, your building must be wired correctly. Each supply (“hot”) conductor must be
protected by a short-circuit protective device and by an overcurrent protective device. The table listed
under
AC inputs
provides speci
fi
cations for the overcurrent protective devices required for single-phase
operation. All protective devices must comply with national standards of the country where the unit is
to be installed. If a protective device interrupts any supply conductor, it must also interrupt all other
supply conductors.
Overcurrent protection is also required for the neutral conductor.
Your electrician should know the appropriate code requirements for your location/site and wire power
distribution to the HP SVS200 accordingly.
HP StorageWorks 200 Storage Virtualization System site preparation guide
41