HP Cisco MDS 9216A Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2 - Page 319
fcoe mode
View all HP Cisco MDS 9216A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 319 highlights
Chapter 5 Quality of Service Commands fcoe mode Send comments to [email protected] fcoe mode To force-enable the FCoE mode on an interface, use the fcoe mode command. To disable FCoE mode on the interface, use the no form of this command. fcoe mode {auto | on} no fcoe mode [auto | on] Syntax Description auto on The interface negotiates the setting with the connected adapter. FCoE negotiation result is ignored and FCoE is set to enabled on the interface. Command Default Auto. Command Modes Interface configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines By default, 10-Gigabit Ethernet interfaces negotiate FCoE capability with the adapter. You can override the negotiation result by force-enabling the FCoE capability. When you set the FCoE parameter to auto, the interface negotiates the setting with the connected adapter. FCoE will not be enabled on the interface if the adapter does not support FCoE. If the mode is set to on, the FCoE negotiation result is ignored and FCoE is set to enabled on the interface. Examples This example shows how to configure an interface to force-enable the FCoE mode: switch)# configure terminal switch(config)# interface ethernet 1/1 switch(config-if)# fcoe mode on This example shows how to disable FCoE for an Ethernet interface: switch)# configure terminal switch(config)# interface ethernet 1/1 switch(config-if)# no fcoe mode Related Commands Command show fcoe Description Displays information about FCoE. OL-16599-01 Cisco Nexus 5000 Series Command Reference 5-3