HP Cisco MDS 9216A Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2 - Page 588

fcflow stats Chapter 8 Fibre Channel Commands Send comments to [email protected] fcflow stats To configure fcflow statistics, use the fcflow stats command. To disable the counter, use the no form of the command. fcflow stats {aggregated index flow-number vsan vsan-id | index flow-number destination-fcid source-fcid netmask vsan vsan-id} no fcflow stats {aggregated index flow-number | index flow-number} Syntax Description aggregated index flow-number vsan vsan-id destination-fcid source-fcid netmask Configures aggregated fcflow statistics. Specifies a flow index. The range is 1 to 2147483647. Specifies a VSAN ID. The range is 1 to 4093. Enters the destination FCID in hexadecimal format. Enters the source FCID in hexadecimal format. Enters the mask for the source and destination FCID (restricted to 6 hexadecimal characters ranging from 0xff0000 to 0xffffff). Command Default None Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines If you enable flow counters, you can enable a maximum of 1024 entries for aggregate flow and flow statistics. Be sure to assign an unused flow index or each new flow. The number space for flow index is shared between the aggregate flow statistics and the flow statistics. Examples The following example enables the aggregated flow counter: switch(config)# fcflow stats aggregated index 1005 vsan 1 The following example disables the aggregated flow counter: switch(config)# no fcflow stats aggregated index 1005 The following example enables the flow counter for a specific flow: switch(config)# fcflow stats index 1 0x145601 0x5601 0xffffff vsan 1 The following example disables the flow counter for index 1001: switch(config)# no fcflow stats index 1001 8-54 Cisco Nexus 5000 Series Command Reference OL-16599-01