HP Cisco MDS 9216A Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2 - Page 626
interface san-port-channel
View all HP Cisco MDS 9216A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 626 highlights
interface san-port-channel Chapter 8 Fibre Channel Commands Send comments to [email protected] interface san-port-channel To configure a SAN port channel interface on a Cisco Nexus 5000 Series switch, use the interface san-port-channel command. The interface san-port-channel command enters interface configuration mode, which includes six commands (each with a no form). To revert to defaults, use the no form of the command. interface san-port-channel port description line shutdown [force] switchport { mode { E | auto} | speed { 1000 | 2000 | 4000 | auto} | trunk { allowed vsan {vsan-id | add vsan-id | all} | mode {auto | on | off}} } no interface san-port-channel port no description no shutdown no switchport { no mode | no speed | no trunk { allowed vsan { vsan-id | add vsan-id | all}| mode } Syntax Description port description line shutdown force switchport Specifies a port number. Enters a line of text to describe the interface. Changes the interface state to administrative down. Forces the interface state to administrative down. Enters configuration parameters for the SAN port channel . Command Default Disabled. Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines Use the no shutdown command to enable the interface. 8-92 Cisco Nexus 5000 Series Command Reference OL-16599-01