HP Cisco MDS 9216A Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2 - Page 660
rscn event-tov
View all HP Cisco MDS 9216A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 660 highlights
rscn event-tov Chapter 8 Fibre Channel Commands Send comments to [email protected] rscn event-tov To configure an event timeout value for a Registered State Change Notification (RSCN) on a specified VSAN, use the rscn event-tov command. To cancel the event timeout value and restore the default value, use the no form of the command. rscn event-tov timeout vsan vsan-id no rscn event-tov timeout vsan vsan-id Syntax Description timeout vsan vsan-id Specifies an event timeout value in milliseconds. The range is 0 to 2000. Specifies a VSAN where the RSCN event timer should be used. The ID of the VSAN is from 1 to 4093. Command Default The default timeout values are 2000 milliseconds for Fibre Channel VSANs. Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines Before changing the timeout value, you must enable RSCN configuration distribution using the rscn distribute command. The RSCN timer is registered with Cisco Fabric Services (CFS) during initialization and switchover. Examples The following example configures an RSCN event timeout value on VSAN 1: switch(config)# rscn event-tov 20 vsan 1 Related Commands Command rscn abort rscn commit rscn distribute clear rscn session show rscn Description Cancels a pending RSCN configuration on a specified VSAN. Applies a pending RSCN configuration. Enables distribution of an RSCN configuration. Clears the RSCN session for a specified VSAN. Displays RSCN configuration information. 8-126 Cisco Nexus 5000 Series Command Reference OL-16599-01