HP Cisco MDS 9216A Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2 - Page 423

Chapter 6 Security Commands resequence Send comments to [email protected] resequence To reassign sequence numbers to all rules in an access control list (ACL) or a time range, use the resequence command. resequence access-list-type access-list access-list-name starting-number increment resequence time-range time-range-name starting-number increment Syntax Description access-list-type access-list access-list-name time-range time-range-name starting-number increment Type of the ACL. Valid values for this argument are the following keywords: • arp • ip • mac Specifies the name of the ACL. Specifies the name of the time range. Sequence number for the first rule in the ACL or time range. Number that the switch adds to each subsequent sequence number. Command Default None Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines The resequence command allows you to reassign sequence numbers to the rules of an ACL or time range. The new sequence number for the first rule is determined by the starting-number argument. Each additional rule receives a new sequence number determined by the increment argument. If the highest sequence number would exceed the maximum possible sequence number, then no sequencing occurs and the following message appears: ERROR: Exceeded maximum sequence number. The maximum sequence number is 4294967295. OL-16599-01 Cisco Nexus 5000 Series Command Reference 6-89