HP EliteBook 735 PC Commercial BIOS UEFI Setup - Page 66
Table 40, Feature, Description, Default, Notes
View all HP EliteBook 735 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
HP PC Commercial BIOS (UEFI) Setup July 2020 919946-004 7.4 BIOS Sure Start Menu Settings menu for enhanced hardware-based assurance that only HP approved Embedded Controller firmware will run on the HP Embedded Controller and that only HP approved BIOS will run on the host CPU. Table 40 BIOS Sure Start Menu features Feature Verify Boot Block on Every Boot BIOS Data Recovery Policy Network Controller Configuration Restore Prompt on Network Controller Configuration Change Dynamic Runtime Scanning of Boot Block Sure Start BIOS Settings Protection Type Setting Setting Action Setting Setting Setting Description When not checked, HP Sure Start verifies the integrity of HP firmware in the nonvolatile (flash) memory before resume from Sleep, Hibernate, or Off. When checked, HP Sure Start verifies the integrity of HP firmware in the nonvolatile (flash) memory across operating system restart (warm reset) in addition to resume from Sleep, Hibernate Off. This setting provides higher security assurance but could increase the time required to restart operating system. The following settings are possible for HP Sure Start- Recovery Policy: • Automatic • Manual Automatic: HP Sure Start automatically repairs any HP firmware integrity issues in the nonvolatile (flash) memory. Manual: HP Sure Start will not repair any HP firmware integrity issues in the nonvolatile (flash) memory until the Windows +Up Arrow+ Down Arrow keys are pressed. NOTE: Manual recovery is intended for use by the system administrator in the event forensic investigation is desired before HP Sure Start repairs the issue. It is not recommended for the typical user. Network Controller Configuration Restore This action restores the network controller parameters to the factory state saved in the HP Sure Start Private nonvolatile (flash) memory. NOTE: This process can take up to 30 seconds. You need to restore this only when the Network Controller Configuration mismatch warning is set. When enabled, HP Sure Start will monitor the network controller configuration and prompt the local user if any changes are detected compared to the factory configuration. The local user has the option to ignore the prompt or restore the network controller to the factory configuration when prompted. When checked, allows HP Sure Start verifies the integrity of the HP firmware in the nonvolatile (flash) memory every 15 minutes while the system is on and the operating system is running. Protects critical BIOS Settings by saving a backup copy and restoring them if altered. Default Unchecked Automatic Checked Checked Unchecked Notes Reboot Required Reboot Required Reboot Required Intel Only Reboot Physical Presence Required Not accessible with no Admin password set © Copyright 2016-2019 HP Development Company, L.P. 7 Security Menu (2019 and older) 66