HP ElitePad Mobile POS G2 Maintenance and Service Guide - Page 79
Battery connector board, that secure the battery connector board to
View all HP ElitePad Mobile POS G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Battery connector board Description Battery connector board (includes cable) Spare part number 744033-001 Before removing the battery connector board, follow these steps: 1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system. 2. Disconnect the power from the tablet by unplugging the power cord from the tablet or the Retail Jacket. 3. Disconnect all external devices from the Retail Jacket. 4. Remove the top cap (see Top cap on page 63). 5. If installed, remove the tablet from the Retail Jacket (see Top cap on page 63). 6. Remove the front cover (see Front cover on page 65). Remove the battery connector board: 1. Turn the front cover upside down with the top toward you. 2. Disconnect the battery connector board cable (1) from the system board. 3. Remove the two Phillips PM1.9×3.0 screws (2) that secure the battery connector board to the front cover. 4. Lift the bottom edge of the battery connector board (3) until the board rests at an angle, and then slide the board out of the opening in the front cover. 5. Remove the battery connector board and cable. Retail Jacket component replacement procedures 71