HP ElitePad Mobile POS G2 Maintenance and Service Guide - Page 93
Fingerprint reader board, Remove the fingerprint reader board
View all HP ElitePad Mobile POS G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Fingerprint reader board Description Fingerprint reader board Spare part number 744042-001 Before removing the fingerprint reader board, follow these steps: 1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system. 2. Disconnect the power from the tablet by unplugging the power cord from the tablet or the Security Jacket. 3. Disconnect all external devices from the Security Jacket. 4. Remove the card reader cover and top cap (see Card reader cover and Top cap on page 77). 5. If installed, remove the tablet from the Security Jacket (see Card reader cover and Top cap on page 77). 6. Remove the front cover (see Front cover on page 80). Remove the fingerprint reader board: 1. Position the rear cover with the bottom toward you. 2. Remove the spring (1) from the spring retention tabs (2). 3. Remove the fingerprint reader board (3) and cable. Reverse this procedure to install the fingerprint reader board. Security Jacket component replacement procedures 85