HP ElitePad Mobile POS G2 Maintenance and Service Guide - Page 82
Credit card reader board, Remove the Phillips PM1.9×3.0 screw
View all HP ElitePad Mobile POS G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Credit card reader board NOTE: The credit card reader board spare part kits do not include the respective cables. The cables are included in the Cable Kit, spare part number 744031-001. Description Left-side credit card reader board Right-side credit card reader board Spare part number 744027-001 744028-001 Before removing the credit card reader boards, follow these steps: 1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system. 2. Disconnect the power from the tablet by unplugging the power cord from the tablet or the Retail Jacket. 3. Disconnect all external devices from the Retail Jacket. 4. Remove the top cap (see Top cap on page 63). 5. If installed, remove the tablet from the Retail Jacket (see Top cap on page 63). 6. Remove the front cover (see Front cover on page 65). Remove the credit card reader boards: 1. Remove the Phillips PM1.9×3.0 screw (1) that secures the left-side credit card reader board to the rear cover. 2. Turn the left-side credit card reader board (2) over so the ZIF connector on the back of the board is accessible. 74 Chapter 5 Removal and replacement procedures