HP Jetdirect 380x HP Wireless Print Server 380x - (English) Setup Guide - Page 27

I/O Card Not Ready and Scanning for SSID would likely appear.

Get HP Jetdirect 380x - 802.11b Wireless Print Server PDF manuals and user guides View all HP Jetdirect 380x manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

Check the print server settings. Since the print server is not yet fully installed (until you complete the procedures in chapters 3 and 4), many parameters will not reflect the operating values needed for your network. For a new print server, the configuration page would display the following factorydefault settings: communication mode "Ad Hoc", network name (SSID) "hpsetup", and encryption type "None". The desired print server status "I/O Card Ready" would not appear until the print server successfully connects to a network. Instead, the messages "I/O Card Not Ready" and "Scanning for SSID" would likely appear. Note To interpret entries and diagnose problems reported on the configuration page, see the HP Jetdirect Print Server Administrator's Guide for this model on the HP Jetdirect CD-ROM provided with the print server. Installing the Print Server Hardware 2-5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
Installing the Print Server Hardware 2-5
Check the print server settings. Since the print server is not yet fully installed (until you
complete the procedures in chapters 3 and 4), many parameters will not reflect the
operating values needed for your network.
For a new print server, the configuration page would display the following factory-
default settings: communication mode “Ad Hoc”, network name (SSID) “hpsetup”, and
encryption type “None”. The desired print server status “I/O Card Ready” would not
appear until the print server successfully connects to a network. Instead, the messages
“I/O Card Not Ready” and “Scanning for SSID” would likely appear.
Note
To interpret entries and diagnose problems reported on the configuration page,
see the
HP Jetdirect Print Server Administrator’s Guide
for this model
on the
HP Jetdirect CD-ROM provided with the print server.