HP LH3000r HP Netserver LH 3/3r User Guide - Page 27
during the boot process.
View all HP LH3000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Chapter 4 Installing Accessory Boards preferred slot locations. If not, consider the boot order (see Figure 4-3) when choosing the accessory board socket in which to install the board. Figure 4-3. Accessory Board PCI and ISA Slots Boot order for PCI controllers is determined by slot location. The system searches for a bootable device in the following order: 1. IDE CD-ROM drive with a bootable CD-ROM. 2. Flexible disk drive with a bootable flexible disk. 3. Embedded SCSI controller or embedded DAC. 4. PCI boards in slots in the following order: 8, 7, 6, 5, 4, 3, 2, 1. This boot order can be changed using the SETUP utility (press [F2] during the boot process). 2. Remove the slot cover for each slot to be used, and store it for future use. If you are installing any full-length PCI boards, also remove the accessory board retainer. Push on the tab on the retainer to release it, and then slide it out of the board guide. 19