HP ProLiant SL390s HP ProLiant SL390s G7 1U half width Server Maintenance and - Page 38
Description, WARNING, To remove the heat sink, CAUTION, Loosen the two mounting pins.
View all HP ProLiant SL390s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Figure 11 Processor locations Item Description 1 Processor 1 2 Processor 2 WARNING: To reduce the risk of personal injury from hot surfaces, allow the heat sink and the processor to cool before touching them. To remove the heat sink: CAUTION: To prevent the heat sink from tilting to one side during installation and removal procedures, use a diagonally opposite pattern (an "X" pattern) when loosening and tightening the two spring-loaded screws. Do not over tighten the heat sink's spring-loaded screws to prevent them from breaking off. A maximum torque of 4 in-Ib is set for the system. 1. Loosen the two mounting pins. 2. Lift the heat sink away from the system board. CAUTION: Place the heat sink down in an upright position with the thermal patch facing upward. Do not let the thermal patch touch the work surface. Removal and Replacement Procedures 38