HP rp5400 Carrier Grade Addendum - rp5400 Series of Servers - Page 27
Step 1., Installing the Slide Tray Assembly
View all HP rp5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Installation Installing the Server in a Rack Step 1. Install the Slide Tray Assembly. 1. Take the tray and place it onto the pins that extend from the slides' inner members. The slots with wide lead-in guides on the side of the tray fit down onto the slides' pins. The flat part of the tray will be on top, and the two spring loaded guide pins in the top of the tray will be located to the right of the center of the tray. Slide the tray all the way down on both sides so that the pins reach the top of the slots in the side of the tray. 2. Use the six M5 x 16 T25 screws (without washers) provided with the slide tray kit to attach the tray to the slides. Three screws are used to attach each slide. Insert the screws through the slides, through the tray and tighten into the threaded nuts located on the inside of the sides of the tray. Figure 1-2 Installing the Slide Tray Assembly Spring Loaded Guide Pins Support Pin Chapter 1 15