HP rp5800 Hardware Reference Guide HP rp5800 - Page 28
Installing a 12-volt Powered USB Expansion Card,
View all HP rp5800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
10. To install a new 12-volt Powered USB expansion card, hold the card just above the PCI Express expansion socket on the system board then move the card toward the rear of the chassis (1) so that the bracket on the card is aligned with the open slot on the rear of the chassis. Press the card straight down into the expansion socket on the system board (2). NOTE: You can install the Powered USB expansion card in either the PCI Express x1 slot or the PCI Express x16 slot, or both. Two 12-volt Powered USB expansion cards are supported. Figure 2-17 Installing a 12-volt Powered USB Expansion Card NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot. 22 Chapter 2 Hardware Upgrades ENWW