Husqvarna AUTOMOWER 115H 4G Owner Manual - Page 14

3 Installation 3.1 Introduction - Installation WARNING: Read and understand the safety chapter before you install the product. CAUTION: Use original spare parts and installation material. 3.3.1 To examine where to put the charging station • Keep a minimum 2 m / 6.6 ft. of free space in front of the charging station. • Keep a minimum of 30 cm / 12 in. of free space to the right and left of the center of the charging station. Note: Refer to www.husqvarna.com for more information about installation. 60- cm / 24- in. 3.2 Before the installation of the wires You can select to attach the wires with stakes or bury them. You can use the 2 procedures for the same work area. • Bury the boundary wire or the guide wire if you are going to use a dethatcher on the work area. If not, attach the boundary wire or guide wire with stakes. • Cut the grass before you install the product. Make sure that the grass is maximum 4 cm / 1.6 in. Note: The first weeks after installation the perceived sound level when cutting the grass may be higher than expected. When the product has cut the grass for some time, the perceived sound level is much lower. • Put the charging station near an outdoor power outlet. • Put the charging station on a level surface. Max 5 cm/2" Max 5 cm/2" 3.3 Before the installation of the product • Make a blueprint of the work area and include all obstacles. • Make a mark on the blueprint where to put the charging station, the boundary wire and the guide wire. • Make an eyelet on the blueprint where the guide wire connects to the boundary wire. Refer to To install the guide wire on page 19. • Fill in holes in the lawn. Note: Holes with water in the lawn can cause damage to the product. Max +/- 2 cm / 0.8 in. • Put the charging station in the lowest possible section of the work area. 14 - Installation 982 - 003 -