Husqvarna AUTOMOWER 115H 4G Owner Manual - Page 20
To put the wire into position with stakes, To bury the boundary wire or the guide wire
View all Husqvarna AUTOMOWER 115H 4G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
3. Cut the guide wire 1-2 cm / 0.4-0.8 in. above each connector. 4. Push the guide wire through the slot in the charging station plate. 5. Push the connector onto the metal pin on the charging station with the mark "G". 6. Put the end of the guide wire at the eyelet on the boundary wire. 7. Cut the boundary wire with a pair of wire cutters. 8. Connect the guide wire to the boundary wire with a coupler. 3.5 To put the wire into position with stakes • Put the boundary wire and the guide wire on the ground. • Put the stakes at a maximum of 75 cm / 30 in. distance from each other. • Attach the stakes to the ground with a hammer or a plastic mallet. CAUTION: Make sure that the stakes hold the boundary wire and the guide wire against the ground. Note: The wire is overgrown with grass and not visible after a few weeks. a) Put the 2 ends of the boundary wire and the end of the guide wire into the coupler. Note: Make sure that you can see the end of the guide wire through the transparent area of the coupler. b) Push the button on the coupler with an adjustable pliers. CAUTION: Twinned cables, or a screw terminal block that is insulated with insulation tape are not satisfactory splices. Soil moisture will cause the wire to oxidize and after a time result in a broken circuit. 9. Attach the guide wire to the ground with stakes or bury the guide wire in the ground. Refer to To put the wire into position with stakes on page 20 or To bury the boundary wire or the guide wire on page 20. 3.6 To bury the boundary wire or the guide wire • Cut a groove in the ground with an edge cutter or a straight shovel. • Put the boundary wire or the guide wire 1-20 cm / 0.4-8 in. into the ground. 3.7 To extend the boundary wire or the guide wire Note: Extend the boundary wire or the guide wire if it is too short for the work area. Use original spare parts, for example couplers. 1. Cut the boundary wire or the guide wire with a pair of wire cutters where it is necessary to install the extension. 2. Add wire where it is necessary to install the extension. 3. Put the boundary wire or the guide wire into position. 4. Put the wire ends into a coupler. Note: Make sure that you can see the ends of the boundary wire or the guide wire through the transparent area of the coupler. 5. Push the button on the coupler with an adjustable pliers. 20 - Installation 982 - 003 -