Husqvarna AUTOMOWER 115H 4G Owner Manual - Page 18
To examine where to put the guide wire, Work area examples, Lawn Coverage
View all Husqvarna AUTOMOWER 115H 4G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Note: When the product cuts grass in the secondary area, the Secondary area mode must be selected. Refer to 2nd area on page 28. 3.3.5 Work area examples D 3.3.4 To examine where to put the guide wire • Put the guide wire in a line at a minimum of 1 m / 3.3 ft. in front of the charging station. A G Min 1m / 3.3ft B C • Make sure that the guide wire has as much free area as possible to the left of the guide wire when facing the charging station. Refer to Guide calibration on page 21. • Put the guide wire minimum 30 cm / 12 in. from the boundary wire. • Do not make sharp bends when you install the guide wire. • If the work area has a slope, put the guide wire diagonally across the slope. • If the charging station is put in a small area (A), make sure that the distance to the boundary wire is at a minimum 2 m / 6.6 ft. • If the work area has a passage (B), make sure that the distance to the boundary wire is at a minimum 2 m / 6.5 ft. If the passage is smaller than 2 m / 6.5 ft., install a guide wire through the passage. Minimum passage between the boundary wire is 60 cm / 24 in. • If the work area has areas which are connected by a narrow passage (B), you can set the product to leave the guide wire after a certain distance (C). The settings can be changed in Lawn Coverage. Refer to To set the Lawn Coverage function on page 23. • If the work area includes a secondary area (D), refer to To make a secondary area on page 17. Put the product in the secondary area and select Secondary area mode. 18 - Installation 982 - 003 -