IBM 43635gu User Guide - Page 47
IDs for hot-swap hard disk drives, Installing a simple-swap SATA hard disk drive
UPC - 883436002950
View all IBM 43635gu manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
6. If you are installing additional hot-swap hard disk drives, do so now. If you have other devices to install or remove, do so now; otherwise, go to "Completing the installation" on page 47. IDs for hot-swap hard disk drives The hot-swap-drive backplane controls the IDs for the internal hot-swap drive bays. The following table lists the IDs for the hard disk drives and backplane that are connected to one channel in the hot-swap models. In the typical configuration, the standard hard disk drives and backplane are connected to channel A. Device ID Drive bay 4 0 Drive bay 5 1 Drive bay 6 2 Drive bay 7 3 Installing a simple-swap SATA hard disk drive Some server models come with simple-swap SATA hard disk drives, which are accessible from the front of the server. Before you install a simple-swap SATA hard disk drive, read the following information: v You can install four simple-swap SATA hard disk drives in the server. v Install the drives in ascending order by bay number. Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all power from the server before you remove or install a simple-swap hard disk drive. Chapter 2. Installing optional devices 33