IBM 43635gu User Guide - Page 58
Installing a hot-swap power supply, these components. If you suspect a problem with one of these parts
UPC - 883436002950
View all IBM 43635gu manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Installing a hot-swap power supply The following notes describe the type of power supply that the server supports and other information that you must consider when you install a power supply: v The type and number of power supplies vary by server model. The server comes with at least one power supply. v Some servers come with a hot-swap power supply that supports redundant mode. The redundant mode requires two operational hot-swap power supplies in the server. This procedure applies only to server models that have hot-swap power supplies. If the server contains a non-hot-swap power supply that requires replacement, the power supply must be replaced by a service technician. When you remove or install a hot-swap power supply, observe the following precautions. Statement 8: CAUTION: Never remove the cover on a power supply or any part that has the following label attached. Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician. Release lever Hot-swap power supply To replace a hot-swap power supply, complete the following steps: 44 System x3200 Types 4362 and 4363: User's Guide