IBM 8676 Installation Guide - Page 33
Completing the installation, Installing the cover and bezel
UPC - 087944770107
View all IBM 8676 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
are tight. Do not overtighten the screws by using excessive force. Heat sink Microprocessor 2 Microprocessor 2 VRM 8. If you have other options to install, install them now. Otherwise, continue with "Completing the installation". Completing the installation This section describes how to complete the installation. Installing the cover and bezel Complete the following steps to install the server cover and bezel: 1. Position the internal cables so they do not interfere with the cover installation. Attention: Before sliding the cover forward, make sure that all the tabs on both the front and rear of the cover engage the chassis correctly. If all the tabs do not engage the chassis correctly, it will be very difficult to remove the cover later. 2. Position the cover on top of the server and slide it forward. Press down on the cover latch. The cover slides forward into position. Ensure that the cover Chapter 2. Installing options 21